Tee8New.exe error

TeeChart VCL for Borland/CodeGear/Embarcadero RAD Studio, Delphi and C++ Builder.
Post Reply
Posts: 53
Joined: Mon Jul 02, 2007 12:00 am

Tee8New.exe error

Post by dpatch » Fri Mar 20, 2009 7:27 pm

I'm trying to run Tee8New.exe and when opening it I get the following message:

"The procedure entry point Chart@UnRegisterTeeTools$qqrpxp17System@TMetaClassxi could not be located in dynamic link library Tee810.bpl

I recently upgraded to v8.04.11395. Did I miss a step when I upgraded?

Thank in advance

Site Admin
Site Admin
Posts: 8853
Joined: Tue Dec 05, 2006 12:00 am
Location: Girona, Catalonia

Post by Yeray » Mon Mar 23, 2009 9:25 am

Hi dpatch,

The installer should update your IDE's search paths and library paths but if the installer didn't prompt any error message, the most probably is that in your IDE there still remain references to the old packages. So, could you check that the new references are in the top of your IDE's search paths and library paths?
Best Regards,
ImageYeray Alonso
Development & Support
Steema Software
Av. Montilivi 33, 17003 Girona, Catalonia (SP)
Image Image Image Image Image Image Please read our Bug Fixing Policy

Post Reply